Limited availability during the holidays
Another busy year is coming to its end, and an exciting year lies ahead. In order to get ready for a fresh new start, our team will spend a few days' rest during the winter holidays. Over the holiday break, we will have reduced staffing from December 20th, 2025, to January 4th, 2026, so please be patient if you do not receive a response as quickly as you normally would.
We send our warmest wishes for happiness, health, and success throughout the coming year. Thank you for your continued support, and may you have a peaceful and blessed Happy Holidays!
I have one slide with multiple text blocks with animations.
Everything works fine, except - I can't find a way to make the slider go into loop, with only one slide available.
I understand, that if I make a slide copy, then it will loop as expected. But as I have multiple text block on the slider, an they are making transition - appears and disappears, I just need this process go "into loop" so all text blocks on slider will appear again, when they are disappeared.
At the moment, most probably, on my site you will see 2 slides, because I have copied them, so they can go into loop" although - I have 2 completely identical slides.
Hey arnisraido,
You can approach this two ways.
You can either keep the two slides and set your layers to be static, so they won't animate in and out when the slide changes.
Or you can use one slide and set loop transition for your layers, so they keep animating.
Tha'ts the problem - we could not get transitions "in loop" to be working with only one slide.
But we will stick by "duplicating" Slide #1
The loop layer transition should work in a single slide as well. How exactly did you set it up ? You need to use the settings located in the Layers -> Transition -> Loop or Middle Transition tab and set the Count to -1 for infinite loop.
In case of a single slide setup, you will need to use the settings located in the Loop or Middle Transition section of the corresponding layers.
You will need to set the opacity to 0, apply the duration and wait values that you want to use, enable the Yoyo and set the Count to -1.
If you time these right, the layers will keep switching/fading in and out. You might also need to set the 'Keep this layer visible until: Forever' depending on your setup so the Infinite works properly.
Testing in the preview window and the timeline view can help a lot with the timings.